9
5. Slide the Seat (23) to the front of the Rail (2).
Next, attach the Rear Stop (87) to the Rail (2)
with two M4 x 8mm Screws (104).
Then, attach the Rail Cap (38) to the Rail (2)
with two M4 x 19mm Screws (69).
2
5
6
38
69
69
87
23
104
105
105
76
84
75
Avoid pinching
the wires
6. While a second person holds the Console (75)
near the Neck (76), plug the Upright Wire (84)
into the receptacle on the Console.
Tip: The
wire connector should slide in easily and
snap into place with an audible click. If it
does not, turn the connector and try again.
Insert the excess wire into the Neck (76) or into
the Console (75).
Tip: Avoid pinching the wires.
Attach
the Console (75) to the Neck (76) with four
M4 x 12mm Screws (105);
start all the Screws,
and then tighten them.
