27
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately. Use only manufacturer-
supplied parts.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
RAIL MAINTENANCE
Regularly clean the carriage rollers and the rail
area over which the carriage rollers move. First,
see assembly step 10 on page 12 and remove the
indicated parts. Next, remove the seat assembly from
the rail. Then, use a damp cloth and a small amount
of mild detergent to remove dust and debris from the
carriage rollers and the rail.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console
to a wireless network, or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does not boot up properly, or if the con-
sole freezes and does not respond, reset the console
to the factory default settings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the top edge of the
console. Using a bent paper clip, press and hold the
reset button inside the opening, and have a second
person plug in the power
adapter. Continue holding
the reset button until the
console turns on. When the
reset operation is complete,
the console will turn off
and then turn back on. If it
does not, unplug and then
plug in the power adapter.
Once the console turns on, check for firmware updates
(see HOW TO CHANGE CONSOLE SETTINGS on
page 23). Note: It may take a few minutes for the
console to be ready for use.
HOW TO ADJUST THE CONSOLE PIVOT AND TILT
If the console feels too loose or does not stay
in place when it is moved from side to side, first
remove the Mount Cover (12). Next, use the included
tool to tighten the M25 Locknut (17) slightly until the
console stays in place when moved from side to side.
Then, press the Mount Cover back into place.
If the console
feels too loose or
does not stay in
place when it is
tilted upward and
downward, first
use a standard
screwdriver to pry
off the Upper and
Lower Console
Covers (22, 23).
12
17
22
23
MAINTENANCE AND TROUBLESHOOTING
A
