27
SYMPTOM: The walking belt slips when walked on
a.
First, remove the key and
UNPLUG THE POWER
CORD.
Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to
7 cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and walk on the incline trainer
for a few minutes. Repeat until the walking belt is
properly tightened.
SYMPTOM: The incline of the incline trainer does
not change correctly
a.
Calibrate the incline system (see step 4 on
page 21).
SYMPTOM: The incline trainer will not connect to
the wireless network
a.
Make sure that the wireless settings on the console
are correct (see page 22).
b.
Make sure that the settings for your wireless net-
work are correct.
c.
If you still have questions, go to support.iFit.com.
SYMPTOM: The tablet holder does not stay in place
a.
Remove the six M4 x 16mm Screws (8) from the
back of the Tablet Holder (65).
b.
Tighten the three indicated screws (a) slightly
(1/4 turn or less) until the Tablet Holder (65) stays
in place when it is rotated to the desired position.
c.
See drawing a above.
Reattach the Tablet Holder
(65) with the six M4 x 16mm Screws (8);
start all
six Screws, and then tighten them. Do not over-
tighten the Screws.
a
8
65
a
8
a
65
b
a
