26
Next, locate the
Reed Switch
(101) and the
Magnet (107)
on the left side
of the Pulley
(42). Turn the
Pulley until
the Magnet
is aligned
with the Reed
Switch.
The
gap between
the Magnet and the Reed Switch must be about
1/8 in. (3 mm).
If necessary, loosen the #8 x 3/4"
Clip Screw (100), move the Reed Switch slightly,
and then retighten the Clip Screw. Then, reattach
the Left Foot Rail Cover with the #8 x 3/4"
Screw
,
and run the incline trainer for a few minutes to
check for a correct speed reading.
SYMPTOM: The walking belt slows when walked on
a.
If an extension cord is needed, use only a 3-con-
ductor, 14-gauge (2 mm
2
) cord that is no longer
than 5 ft. (1.5 m).
b.
If the walking belt is overtightened, incline trainer
performance may decrease and the walking belt
may become damaged. First, adjust the incline to
40 percent. Then, remove the key and
UNPLUG
THE POWER CORD.
Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
3 to 4 in. (8 to 10 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and walk on
the incline trainer for a few minutes. Repeat until
the walking belt is properly tightened.
c.
Your incline trainer features a walking belt coated
with high-performance lubricant.
IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform
unless instructed to do so by an authorized
service representative. Such substances may
deteriorate the walking belt and cause exces-
sive wear.
If you suspect that the walking belt
needs more lubricant, see the front cover of this
manual.
d.
If the walking belt still slows when walked on, see
the front cover of this manual.
SYMPTOM: The walking belt is not centered
between the foot rails
a.
IMPORTANT: If the walking belt rubs against the
foot rails, the walking belt may become dam-
aged.
First, remove the key and
UNPLUG THE
POWER CORD.
If the walking belt has shifted to
the left,
use the hex key to turn the left idler roller
screw clockwise 1/2 of a turn;
if the walking belt
has shifted to the right,
turn the left idler roller
screw counterclockwise 1/2 of a turn. Be careful
not to overtighten the walking belt.
Then, plug in
the power cord, insert the key, and walk on the
incline trainer for a few minutes. Repeat until the
walking belt is centered.
3–4 in.
b
Idler Roller Screws
a
Foot Rails
107
42
100
101
1/8 in.
Top View
