10
5.
Incline the radar bracket n°2 in direction to the pavement
until the notch appears (Figure 9).
Figure 9 : 45° tilt angle
6.
Firmly tighten the screws.
Figure 10: view from the front of the signal head: radar is leaning
4.2.1
Key points
•
The tilt angle must be in direction of the pavement, which means the side where the traffic light is. When you
are in front of the radar: if the traffic light is on the right side of the vehicles, the housing of the radar has to be
inclined to the right (Figure 8 & Figure 10). If the traffic light is on the left side of the vehicles, the housing of
the radar has to be inclined to the left (Figure 11 &Figure 12).
Figure 11: Traffic light is on the left side from the cars
Figure 12: View from behind: installation set when the
traffic light is on the left side from the cars.
