iComfort IC-1126, Instruction Manual

Page: 4 / 28

P a g e | 3
7. INSTALLATION
The ic1126 massage chair comes partly assembled.
• Assemble this massage chair according to the installation instructions provided in this guide.
• Check the parts list carefully to make sure nothing is missing.
• Sitting in the massage chair before it is completely assembled could result in permanent damage to
the chair and personal injury.
• This massage chair is equipped with a cord having a grounding conductor. The cord must be
plugged into an appropriate AC wall outlet.
• If the massage chair fuse is burned out, please use the chair’s main On/Off button to turn it off and
unplug the AC power cord. You can unscrew the fuse located in the switch box at the bottom right of
the chair in the back.
Use a same size and type of fuse to replace the old one and then cover the lid.
You can call iComfort ® at 1 ‐ 866 ‐ 967 ‐ 7333 ext 227 if you need help.
CAUTION: Never substitute a missing part with one of your own. If a part is missing, contact customer
service at: 1 ‐ 866 ‐ 967 ‐ 7333 ext 227
Unpacking
1) Remove the massage chair, cushions and accessories from the main box.
2) Remove all plastic wraps.
3) Slowly lift the backrest up to approximately 120 degrees until you hear a light ‘click’ sound. This
signifies the backrest is secured to the seat area.
Shoulder massage pads installation
a) Open the shoulder massage pads by pulling the zipper. Connect the air tube between backrest and
the shoulder massage pad. Insert the guide posts of the shoulder massage pad into the
corresponding holes on the backrest frame (Figure 1).
IMPORTANT: Avoid bending the air tube.
b) Press the shoulder massage pad and fix it on the backrest frame with the two provided screws,
check the air tube whether it is bent (Figure 2).
c) Pull the zipper up (Figure 3).
d) The installation finished (Figure 4).
Repeat these instructions to install the shoulder massage pad on the other side of the massage chair.