![background image](http://html2.mh-extra.com/html/icom/id-52a/id-52a_basic-manual_3773226078.webp)
D-STAR OPERATION
65
D-ST
AR GUIDE
■
When receiving no reply
To communicate through the repeater, your signal must access to the repeater. The
following chart is designed to help you correct problems which are not equipment
malfunctions.
“AM” indicates the PDF type Advanced manual.
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
After your call, the
repeater does not
return a status reply.
The repeater setting is
wrong.
Select the correct repeater.
Correct the repeater
frequency, frequency offset,
or duplex settings.
—
Your transmission did not
reach the repeater.
Wait until you are closer to
the repeater and try again.
—
Try to access another
repeater.
—
After your call, the
repeater replies ‘UR?’
and its call sign.
The call was successfully
sent, but no station
immediately replied.
Wait for a while, and try
again.
—
After your call, the
repeater replies ‘RX’ or
‘RPT?’ and the access
repeater’s call sign.
Your own call sign (MY) has
not been set.
Set your own call sign (MY). p. 45
Your own call sign (MY)
has not been registered on
a gateway repeater, or the
registered contents do not
match your transceiver’s
settings.
Register your own call sign
(MY) on a gateway repeater,
or confirm the registration of
the call sign.
After your call, the
repeater replies
‘RPT?’ and the access
repeater’s call sign.
The call sign of the
destination repeater is
wrong.
Correctly set the destination
repeater call sign.
—
After your call, the
repeater replies ‘RPT?’
and the destination
repeater’s call sign.
The repeater cannot connect
to the destination repeater.
Check the repeater settings.
—
The repeater is busy.
Wait for a while, and try it
again.
Even holding down
[DR], the DR screen is
not displayed.
There is no repeater list in
your transceiver.
Import the repeater using a
microSD card.
Directly enter the Repeater
list data into the transceiver. AM
The Lock function is
activated.
Hold down [
] for 1
second to turn OFF the Lock
function.