Icom ID-5100A, Basic Manual

Page: 56 / 108

43
4
D-STAR OPERATION
New2001 New2001
■
Troubleshooting
To communicate through the repeater, your signal must access to the repeater. When your signal accesses your local repeater,
but it is not sent to the destination repeater, the repeater replies with an status message.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater does
not return a status reply. • The repeater setting is wrong.
• Your transmission did not reach the repeat-
er.
• Select the correct repeater.
• Correct the repeater frequency, frequency
offset, or duplex setting.
• Wait until you are closer to the repeater and
try again.
• Try to access another repeater.
p. 31
—
—
—
After your call, the repeater
replies ‘UR?’ and its call
sign.
• The call was successfully sent, but no sta-
tion immediately replied.
• Wait for a while, and try again. —
After your call, the repeater
replies ‘RX’ or ‘RPT?’ and the
access repeater’s call sign.
• Your call sign (MY) has not been set.
• Your call sign (MY) has not been registered
on a gateway repeater, or the registered
contents do not match your transceiver’s
setting.
• Set your call sign (MY).
• Register your call sign (MY) on a D-STAR
repeater, or confirm the registration of the
call sign.
p. 24
p. 27