![background image](http://html2.mh-extra.com/html/icom/ic-v85/ic-v85_instruction-manual_3766801034.webp)
21
4
BASIC OPERATION
D
D
Weather channel selection
q
Push
[MR]
several times to select weather channel group.
w
Push
[
Y
Y
]
or
[
Z
Z
]
several times to select the desired
weather channel.
e
Push
[MR]
to select memory mode, or push
[CLR]
to se-
lect VFO mode.
D
D
Weather alert function
An NOAA broadcast station transmits weather alert tone be-
fore important weather announcements. When the weather
alert function is turned ON, the selected weather channel is
monitored each 5 sec. for the announcement. When the alert
signal is detected, the “ALt” and the WX channel are dis-
played alternately and sounds a beep tone until the trans-
ceiver controls are manipulated. The previously selected
weather channel is checked periodically during standby or
while scanning.
q
Select the desired weather channel.
w
Turn the weather alert function ON in
SET MODE
.
➥
Push
[FUNC]
and
[
SET
]
(8) to enter
SET MODE
.
➥
Push
[
Y
Y
]
or
[
Z
Z
]
to select the weather alert item, then
rotate
[VOL]
to set ON.
➥
push
[
✱
ENT
]
(or
[CLR]
) to exit
SET MODE
.
e
Select the desired stand-by condition.
• Select VFO, memory or call channel.
• Scan or priority watch operation can also be selected.
r
When the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
• Weather alert function OFF
➥
Turn the weather alert function OFF in
SET MODE
.
• Repeat above procedure described at step
w
NOTE:
While receiving a signal (on a frequency other than
the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec.
(approx.)
in case the alert function is turned ON. This is caused by
the WX alert function. To eliminate the interruptions, set the
weather alert item OFF in
SET MODE
.
Shows above indications alternately.
USING
SET MODE
Weather channel group indication
■
Weather channel operation
(USA version only)