■
General
When using a repeater, the transmit frequency is shifted from
the receive frequency by the offset frequency. It is convenient
to program repeater information into memory channels.
q
Set the receive frequency (repeater output frequency).
w
Push [A•
FUNC
] and [4•
DUP
] several times to select “–” or “+.”
• “–” indicates the transmit frequency is shifted down; “+” indicates
the transmit frequency is shifted up.
• Blinking “–” or “+” indicates the reversed duplex mode is selected
in
SET MODE
(p. 58).
e
Push [A•
FUNC
] and [1•
TONE
] several times to activate the
subaudible tone encoder, if required.
• “ ” appears.
• Select the desired subaudible tone frequency, if necessary.
(p. 18)
r
Push and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• If “OFF” appears, check the offset frequency (see next page for
details) and direction.
t
Release [PTT] to receive.
y
Push and hold [MONI] to check whether the other station’s
transmit signal can be directly received.
■
Reversed duplex mode
When the reversed duplex mode is selected, the receive fre-
quency shifts.
(Transmit frequency shifts in normal duplex mode.)
Each receive and transmit frequency is shown in the table
below with the following conditions;
IC-V82
Input frequency
: 145.30 MHz
Direction
: – (negative)
Offset frequency
: 0.6 MHz
IC-U82
Input frequency
: 439.80 MHz
Direction
: – (negative)
Offset frequency
: 5 MHz
q
Push [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
w
Push [
Y
Y
] or [
Z
Z
] several times until “REV” appears.
e
Rotate [VOL] to turn the reversed duplex mode ON or
OFF.
r
Push [
✱
•
ENT
] (or [D•
CLR
]) to exit
SET MODE
.
USING
SET MODE
17
5
REPEATER OPERATION
4
5
IC-V82
IC-U82
Reversed
OFF
ON OFF
ON
Rx freq. 145.30 MHz 144.70 MHz 439.80 MHz 434.80 MHz
Tx freq.
144.70 MHz 145.30 MHz 434.80 MHz 439.80 MHz
