![background image](http://html1.mh-extra.com/html/icom/ic-u80/ic-u80_instruction-manual_2038107058.webp)
52
New2001
New2001
TROUBLE SHOOTING
13
If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
The transceiver does not
turn ON.
• The battery is exhausted.
• The battery polarity is reversed.
• Loose connection of a battery pack or case.
• Charge the battery pack, or replace the batteries.
• Correct the reverse polarity.
• Clean battery terminals.
pp. 11–14
p. 14
p. 14
No sound comes from the
speaker.
• The audio volume is too low.
• An external speaker or a cloning cable is
connected to the [SP] jack.
• Rotate
[VOL] to adjust to a desired audio level.
• Check the external speaker connection or remove
the cloning cable.
p. 15
–
Transmitting is impossible.
• The battery is exhausted.
• TX permission is inhibited.
• Charge the battery pack, or replace the batteries.
•
Set the TX permission setting to “ON” in the Set mode.
pp. 11–14
p. 42
Transmitting using the VOX
function is impossible.
• The VOX gain is set to
OFF or too low.
• The microphone gain is
too low.
•
Set the VOX gain to a suitable level.
•
Set the microphone gain to a suitable level.
pp. 42, 56
p. 42
Contacting with another
station is impossible.
• A different tone or code is used for the tone/
DTCS squelch.
• Check the tone/DTCS by performing a tone scan.
p. 35
Frequency cannot be set.
• The Key Lock function is activated.
• The memory mode or Call channel mode is
selected.
• Push
[FUNC](
M
)
, then hold down [
](# ENT) for 1
second to cancel the Key Lock function.
• Push
[VFO/MR/CALL] one or more times to select
the VFO mode.
p. 18
p. 16
A programmed scan does
not start.
• The memory mode or Call channel mode is
selected.
• The same frequency has been programmed
in the scan edge channels, “XA”–“Xb.”
• Push
[VFO/MR/CALL] one or more times to select
the VFO mode.
• Program different frequencies- in the scan edge
channels.
p. 16
p. 26
A memory scan does not
start.
• The VFO mode or Call channel mode is se
-
lected.
• Only one or no memory channel has been
programmed.
• Push
[VFO/MR/CALL] one or more times to select
the memory mode.
• Program two or more memory channels.
p. 16
p. 26
The displayed frequency is
erroneous.
• The CPU has malfunctioned.
• External factors have caused a fault.
• Reset the transceiver.
• Remove and re-attach the battery pack or case.
p. 51
p. 2