3
2
BASIC OPERATION
Receiving and transmitting
Turning ON the transceiver
Hold down [VOL] for 1 second to turn ON the
transceiver.
• The transceiver searches a satellite.
• When the transceiver connected and registered to
the satellite, the status “IDLE,” transceiver name, and
Talkgroup name is displayed.
Push [Last Call] to playback the received call.
Push [UP] or [DOWN] to display the Talkgroup List.
Rotate Talkgroup selector to select a talkgroup.
Receiving
When receiving, “LISTENING,” and the source
transceiver’s name are displayed, and audio should
be heard.
Rotate [VOL] to adjust the audio output level.
Last Call
Ignore
LISTENING
TRANSCEIVER2
TALKGROUP01
NOTE:
The transceiver receives and transmits using
several satellites orbiting the same orbit. Receiving
and transmitting may fail, depending on the satellite
position or any obstacles between the transceiver and
satellites.
Transmitting
CAUTION: DO NOT
transmit without an antenna.
1. Hold down [PTT].
“REQUESTING” is displayed while the transceiver
requests the transmission.
2. When “TALKING” is displayed, speak at your
normal voice level.
You can continuously transmit up to the period of
time allowed by the system.
Last Call
Scan
TALKING
TRANSCEIVER1
TALKGROUP01
NOTE:
• If the connection becomes poor while transmitting,
the transceiver sounds the beep “PuPu” in 1.5 second
intervals.
• You cannot transmit while listening to the received audio.
the beep “Pi” and the display “OPEN.”
Scan and Ignore
Assign the function to the [P2] key in the Menu
screen to use Scan function.
[OK] > Functions > Key Setup >
P2 Key
[Scan]
Push [P2] to scan a call.
• “ ” blinks while scanning.
• “ ” is displayed when a scan is paused.
When a Scan is paused by detecting a signal, [P2 key]
changes from Scan to Ignore.
[Ignore]
Push [P2] to ignore the received call.
• The scan starts again except in the selected Talkgroup.
Push [P2]
to exit the Scan function.
Hold down
