![background image](http://html1.mh-extra.com/html/icom/ic-m510bb/ic-m510bb_instruction-manual_4733540104.webp)
91
13
TROUBLESHOOTING
The transceiver does not turn ON.
z
There is a bad connection to the power supply.
→
Check the connection to the transceiver and power supply. (p. 82)
z
The fuse is blown.
→
Repair the problem, and then replace the fuse. (p. 83)
Little or no sound comes from the speaker.
z
The squelch level is set too high.
→
Set the squelch to the threshold point. (p. 11)
z
The volume level is set too low.
→
Set the volume level to a suitable level. (p. 11)
You cannot transmit with high power.
z
Some channels are set for low power or receive only by regulations.
→
z
The output power is set to low.
→
Push
to select high power. (p. 6)
Scan does not start.
z
More than 2 favorite channels are not set.
→
Set at least 2 favorite channels. (p. 15)
No beep sounds.
z
The Key Beep function is OFF.
→
Turn ON the function. (p. 76)
Individual or Group ID cannot be set.
z
The entered ID code is incorrect. The first digit must be set to between ‘1’ and ‘9’ for an
Individual ID.
→
Enter a correct ID code. (p. 17)
“??” blinks instead of the position and time.
z
Four hours have passed since you manually entered the position.
z
The GPS position is invalid.
→
Enter the position and time. (p. 18)
“No Position” and “No Time” are displayed instead of the position and time.
z
The GPS signal is not correctly received.
→
Check the GPS antenna connection and position. (p. 81)
→
Check the cable connection to NMEA In/Out leads. (p. 81)
→
Check the transceiver is located where the GPS antenna has a clear view to
receive signal from satellites. (pp. 81, 84)
z
The position and time have not been manually entered.
→
Enter the position and time. (p. 18)
Sensitivity is too low, and only strong signals can be heard.
z
The antenna is defective or the coaxial cable connector is shorted or cut.
→
Repair the problem and then reconnect to the antenna connector. (p. 81)
Communication cannot be established.
z
The antenna is defective or the coaxial cable connector is shorted or cut.
→
Repair the problem and then reconnect to the antenna connector. (p. 81)