PRECAUTIONS
A-7377H-2EX
Printed in Japan
© 2017 Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
- 4 -
Thank you for choosing this Icom product.
READ ALL PRECAUTIONS
carefully and completely
before using this product.
- 1 -
The AMBE+2™ voice coding Technology embodied in this
product is protected by intellectual property rights including
patent rights, copyrights and trade secrets of Digital Voice
Systems, Inc. This voice coding Technology is licensed
solely for use within this Communications Equipment.
The user of this Technology is explicitly prohibited from
attempting to extract, remove, decompile, reverse engineer,
or disassemble the Object Code, or in any other way
convert the Object Code into a human-readable form. U.S.
Patent Nos.
#5,870,405, #5,826,222, #5,754,974, #5,701,390,
#5,715,365, #5,649,050, #5,630,011, #5,581,656,
#5,517,511, #5,491,772, #5,247,579, #5,226,084 and
#5,195,166.
VOICE CODING TECHNOLOGY
ABOUT GPS/GLONASS
RECEIVER
CLEAN THE TRANSCEIVER THOROUGHLY WITH
FRESH WATER
after exposure to saltwater, and dry
it before operating. Otherwise, the transceiver's keys,
switches and controllers may become unusable, due to salt
crystallization, and/or the charging terminals of the battery
pack may rust.
NOTE:
If the transceiver’s waterproof protection appears
defective, carefully clean it with a soft, wet (fresh water)
cloth, then, dry it before operating.
The transceiver may lose its waterproof protection if the
case, jack cap, or connector cover is cracked or broken, or
the transceiver has been dropped.
FCC INFORMATION
RECOMMENDATION
• FOR CLASS A UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is
likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
WORD
DEFINITION
R
DANGER!
Personal death, serious injury or an explosion may occur.
R
WARNING!
Personal injury, fi re hazard or electric shock may occur.
CAUTION
Equipment damage may occur.
NOTE
If disregarded, inconvenience only. No risk of personal injury, fi re or electric shock.
R
DANGER! NEVER
short terminals of the battery pack.
This may damage not only the battery pack, but also the
transceiver.
R
DANGER! NEVER
operate the transceiver near
unshielded electrical blasting caps or in an explosive
atmosphere.
R
DANGER!
Use and charge only specifi ed Icom battery
packs with Icom transceivers or Icom chargers. Only
Icom battery packs are tested and approved for use with
Icom transceivers or charged with Icom chargers. Using
thirdparty or counterfeit battery packs or chargers may
cause smoke, fi re, or cause the battery to burst.
R
WARNING! NEVER
operate the transceiver with a
headset or other audio accessories at high volume levels.
The continuous high volume operation may cause a ringing
in your ears. If you experience the ringing, reduce the
volume level or discontinue use.
R
WARNING! NEVER
operate the transceiver while driving
a vehicle. Safe driving requires your full attention—anything
less may result in an accident.
CAUTION: NEVER
use harsh solvents such as Benzine
or alcohol when cleaning, because they will damage the
transceiver surfaces.
CAUTION: NEVER
carry the transceiver by holding the
antenna.
CAUTION: CONFIRM
the fl exible antenna, battery pack
and jack cover are securely attached to the transceiver,
and that the antenna and battery pack are dry before
attachment. Exposing the inside of the transceiver to dust or
water will result in serious damage to the transceiver.
DO NOT
use or place the transceiver in direct sunlight or
in places with temperatures below –30°C (–22°F) or above
+60°C (+140°F). The basic operations of the transceiver
are guaranteed within the specifi ed operating temperature
range. However, the Liquid Crystal Display may not operate
correctly, or show an indication in the case of long hours of
operation, or after being placed in extremely cold areas.
DO NOT
modify the transceiver. The specifi cations may
change and then the transceiver may not comply with
the requirements of required regulations. The transceiver
warranty does not cover any problems caused by
unauthorized modifi cation.
BE CAREFUL!
The trasceiver may become hot when
operating it continuously for long periods of time. This may
damage the transceiver.
BE CAREFUL!
The transceiver meets IP68 requirements
for dust-tight and waterproof protection. However, once the
transceiver has been dropped, dust-tight and waterproof
protection cannot be guaranteed because of possible
damage to the transceiver’s case or the waterproof seal.
Even when the transceiver power is OFF, a slight current
still fl ows in the circuits. Remove the battery pack from the
transceiver when not using it for a long time. Otherwise, the
installed battery pack will become exhausted, and will need
to be recharged or replaced.
ALWAYS
turn OFF the transceiver power before connecting
any external devices.
EXPLICIT DEFINITIONS
PRECAUTIONS
VHF P25 TRANSCEIVERS
UHF P25 TRANSCEIVERS
Iç-F7010T/Iç-F7010S
An internal GPS or GLONASS receiver may not work if the
transceiver transmits or receives in the frequency ranges
as shown below. This problem is made in the internal circuit
and does not indicate a transceiver malfunction.
For the IC-F7010T/IC-F7010S
(Unit: MHz)
GPS receiver
GLONASS receiver
Transmit
142.850 ~ 142.860
145.275 ~ 145.945
157.135 ~ 157.145
159.805
~
160.540
Receive
146.845 ~ 147.110 149.745 ~ 150.790
For the IC-F7020T/IC-F7020S
(Unit: MHz)
GPS receiver
GLONASS receiver
Transmit
392.840 ~ 392.865 399.515 ~ 401.343
Receive
443.545 ~ 444.065
449.335
~
451.425
Icom, Icom Inc. and the Icom logo are registered trademarks
of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia, Australia, New
Zealand, and/or other countries.
AMBE+2 is a trademark and property of Digital Voice Systems Inc.
All other products or brands are registered trademarks or
trademarks of their respective holders.
CAUTION:
Changes or modifi cations to this transceiver,
not expressly approved by Icom Inc., could void
your authority to operate this transceiver under FCC
regulations.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the condition that this device does
not cause harmful interference.
Icom is not responsible for the destruction or damage to
the Icom transceiver, if the malfunction is because of:
• Force majeure, including, but not limited to, fi res,
earthquakes, storms, fl oods, lightning, other natural
disasters, disturbances, riots, war, or radioactive
contamination.
• The use of Icom transceivers with any equipment that is
not manufactured or approved by Icom.
Iç-F7020T/Iç-F7020S
