![background image](http://html.mh-extra.com/html/icom/ic-f7000/ic-f7000_service-manual-addendum_612657038.webp)
5-5 TRANSMITTER ADJUSTMENTS
The following adjustments must be performed at “ADJUSTMENT MODE” after “SWR DETECTOR” and “RECEIVER”
ADJUSTMENTS in the SECTION 5-3 and 5-4.
TRANSMIT
PEAK AND
TOTAL GAIN
(TX PEAK)
(TOTAL GAIN)
TX POWER
(HIGH)
(MIDDLE)
(LOW)
SWR
DETECTOR
1
2
1
2
1
2
1
2
1
2
• While pushing HM-146’s [CALL]
switch and RX-26’s [EMG] switch, turn
power ON.
• Connect an audio generator to the
[MIC] connector and set as:
Frequency
: 1.5 kHz
Level
:
3
mV
• Push [1] switch to enter the TX
adjustment mode (LCD displayed: “TX
SET”).
• P u s h [ E N T ] sw i t c h , t h e n t h e
transceiver is transmitting.
• After setting 50 W, push the [OK]
switch to write the adjustment value in
the memory.
• LCD displayed :“TX POWER HIGH”
• Set the audio generator as:
Frequency
: 1.5 kHz
Level
:
30
mV
• After setting 88 W, push the [OK]
switch to write the adjustment value in
the memory.
• LCD displayed :“TX POWER MID”
• Set the audio generator as:
Frequency
: 1.5 kHz
Level
:
30
mV
• After setting 50 W, push the [OK]
switch to write the adjustment value in
the memory.
• LCD displayed :“TX POWER LOW”
• Set the audio generator as:
Frequency
: 1.5 kHz
Level
:
30
mV
• After setting 10 W, push the [OK]
switch to write the adjustment value in
the memory.
• LCD displayed :“SWR1.0”
• LCD displayed :”SWR2.0”
Rear
panel
Rear
panel
Rear
panel
Rear
panel
Rear
panel
Connect an RF power
meter to the [ANT]
connector.
Connect an RF power
meter to the [ANT]
connector.
Connect an RF power
meter to the [ANT]
connector.
Connect an RF power
meter to the [ANT]
connector.
Connect an RF power
meter to the [ANT]
connector.
Connect the 100 ohms
load (or SWR 2 dumy
load) to the [ANT]
connector.
Maximum
output power
50 W
88 W [AUS]
125 W [OTH]
50 W
10 W
MAIN
RC-26
RC-26
RC-26
RC-26
L706
[VOL]
DIAL
[VOL]
DIAL
[VOL]
DIAL
[VOL]
DIAL
ADJUSTMENT
ADJUSTMENT CONDITIONS
UNIT
LOCATION
VALUE
UNIT
ADJUST
MEASUREMENT
ADJUSTMENT
• Push the [OK] switch to write
the adjustment value in the
memory.
5 - 9