![background image](http://html.mh-extra.com/html/icom/ic-a24/ic-a24_instruction-manual_612411025.webp)
20
6
VOR NAVIGATION (IC-A24 ONLY)
■
Flying to a VOR station
The IC-A24 shows the deviation from a VOR station.
q
Select a VOR station on your aeronautical chart and push
the keypad or rotate [DIAL] to set the frequency of the sta-
tion.
• The course indicator indicates where you are located on a radial
from the VOR station.
• The course indicator shows ‘- -’ when either aircraft is too far
away from the VOR station or the frequency is not set correctly at
the VOR station.
w
Select the ‘TO’ flag when flying to the VOR station, or se-
lect the ‘FROM’ flag when flying away from the VOR sta-
tion.
• Push
,
then push [2•
TO
] to select ‘TO’.
• Push
,
then push [3•
FROM
] to select ‘FROM’.
e
Push
, then push [4•
CDI
] to select the CDI (Course De-
viation Indicator) mode.
• The course indicator shows ‘OF’ when the desired VOR signal
cannot be received.
NOTE:
When the CDI mode is selected, the operating fre-
quency cannot be changed. To set the operating fre-
quency, select the DVOR mode in advance.
r
The course deviation needle appears when your aircraft is
off course from the VOR station.
• ‘
Ω
’ or ‘
≈
’ appears to indicate your aircraft is off course to the right
or left, respectively. Correct your course until ‘
Ω
’ or ‘
≈
’ disap-
pears. Each arrow represents a two-degree deviation.
t
Push
, then push [1•
DVOR
] to exit the CDI mode.
VOR INDICATOR NOTE
‘loc’ appears on the function display as shown below when
a localizer signal is received.
However, the function display does not indicate additional
information about the localizer signal.
NOTE: For U.S.A. version only
IC-A24’s VOR and CDI Navigation features are supplemen-
tal aids to navigation only, and are not intended to be a sub-
stitute for accurate (primary) VOR/CDI or landing service
equipment.
6
IC-A24_A6-5.qxd 2007.04.23 4:32 PM Page 21