![background image](http://html2.mh-extra.com/html/icom/ic-756pro-iii/ic-756pro-iii_alignment-procedure_4134000005.webp)
M a i n B o a r d
Initial setup for alignment
- Reset the microprocessor (Hold “F-INP” and “M-CL” buttons and turning radio on)
- Setup the radio as below
- Frequency:
14.100000MHz
- Filter:
2.4KHz
- Mode:
USB
- Pre-amp:
P.AMP1
- Antenna:
ANT1
- Meter:
Po meter
- Attenuater:
OFF
- AGC:
MID
- VOX:
OFF
- Tuner:
OFF
- Monitor:
OFF
- Noise Blanker: OFF
- NR SW:
OFF
- RF/SQL:
Center
- Balance:
Center
- NR Level:
CCW
- MIC Gain:
Center
- RF Power:
CW
- COMP Level:
Center
- KEY Speed:
Center
- BK-IN Delay: Center
- Notch:
OFF
- Notch
Center
- CW Pitch:
Center
- RIT:
OFF
- Delta TX:
OFF
Transmitter
- Connect RF power meter to ANT connector
- Connect AF signal generator to mic connector
- Apply 1.5KHz/1mV signals to mic connector
- Transmit
- Adjust MIC GAIN pot on the front panel for 50W
- Adjust L261 for maximum RF output power