2
INSTALLATION AND CONNECTIONS
2-4
dash
dot
com
[PHONES/SP]
（
Headphone/External Speaker
）
Jack
[MIC] Connector
Controller
Set the switch under con-
troller to “PHONES” to use
headphone and set “SP” to
use speaker.
Bottom of the
controller
SP-35 (optional)
A jack to connect the paddle
with electrode control on the
end terminal.
Connect to the
[KEY]
Jack
of the Main unit when using
an Electric keyer.
（
p. 2-5)
※
Set internal keyer in de-
fault but it can be changed
by the “Keyer” Set mode
(AI sec. 4)
Connect to the
[CONTROLLER]
connector of the Main unit
Do not connect 2 microphones at same time.
Both microphone have transmission if they are
connected to controller and transceiver.
OPC-589
HM-36
SM-50
• External Keypad
Control the CW memory keyer transmission from external keypad
by connecting control circuit to MIC connector.
Set the “Keyer” item in the “Connectors” Set mode to “ON,” to use
external keypad. (AI sec. 17)
• Data transmission (AFSK)
Connect TNC
(
Terminal Node Controller) to [MIC] connector to
enable data transmission
（
AFSK). (AI sec 18)
HM-151
HM-198
Adapter cable＋Microphone
External spaeaker
Headphone
[ELEC-KEY]
（Electronic keyer） Jack
CAUTION: NEVER
connect or use the option-
al HM-151 (microphone) with any other trans-
ceiver. This could damage the transceiver. The
HM-151 is designed to use with the IC-7000/
IC-7100 series ONLY.
Connecting accessories to the controller
The transceiver accepts head-
phones with maximum 5 mW in
to an 8
Ω
impedance.
The sound level may differ, de-
pending on the headphones.
3.5(d) mm/
1
⁄
8
˝ plug
3.5(d) mm/
1
⁄
8
˝ plug
