14
4
SCAN
■
Dynamic Group Scan
The Dynamic Group Scan can instantly detect a signal that a group member transmitted
by scanning the Tag channels in the Dynamic Group Scan.
The transceiver transmits on the last channel that a group member used. If the
transceiver detects a signal on the channel with no code, or a code that is different from
the code set in the transceiver, the transceiver searches for another channel that is not
being used, and start communicating.
Therefore, all group members can continuously communicate without interference from
other signals.
NOTE:
•
“CB-05,” “RPT-05,” and “CB-35” are for only emergency use. Therefore, these
channels cannot be scanned.
•The transceiver must scan using this scan mode to detect a signal and start
communicating on the channel.
•The transceiver scans only Tag channels in the zone that you select. (p. 4)
•
CB channels 9 to 20 in the Zone 1 are preset as Tag channels for this scan mode by
default.
1. Select “Dyn Grp Scan (Dynamic Group Scan)” in the
•“ ” is displayed on the operating screen.
2. Open the “Dynamic Group” screen.
[MENU] > Scan >
Dynamic Group
3.
Select “CTCSS” or “DTCS,” and then push [►] or
[ENT].
4.
Push [▲] or [▼] to set a CTCSS tone frequency or
DTCS code, and then push [ENT] to set it.
L
See page 16 for the details on the CTCSS/DTCSS.
5.
Push [SCAN] to start the scan.
•“
” blinks.
6.
When a signal with the same CTCSS tone frequency or
DTCS code is received, the scan stops.
7.
Push [SCAN] to stop the scan.
Scan start channel
