4
2
BASIC OPERATIONS
■
Turning ON the transceiver
1. Hold down [
] for 2 seconds to turn ON the
transceiver.
2. If the transceiver is programmed with a start-up
password, enter the password.
TIP:
•
Push [▲] and [▼] to select a number.
•
Push [◄] and [►] to select a digit to enter.
3. Push [ENT] to enter the operating screen.
L
If an incorrect password is entered, you cannot open
the operating screen. Enter the correct password again
in step 2.
■
Selecting a channel
z
Push [▲] or [▼] to select a channel.
•
When CB channel 1 is selected, two beeps sound.
•The channel name is displayed.
L
Holding down [▲] or [▼] continuously changes a channel
until CB channel 1 is selected.
D
Selecting a zone
You can select a zone only when two or more zones are set.
[MENU] >
Zone
1. Push [MENU].
•The “Menu” screen is displayed.
2.
Push [▲] or [▼] to select “Zone,” and then push [►] or
[ENT].
•
The “Zone” screen is displayed.
3.
Push [▲] or [▼] to select a zone, and then push [ENT]
to set it.
L
Push [CLEAR] to return to the previous screen.
NOTE:
•“CB-05,” “RPT-05,” and “CB-35” channels are for only
emergency use.
•No voice transmissions are permitted on “CB-22” and
“CB-23” (voice operation is inhibited on these channels).
•
“CB-61,” “CB-62,” and “CB-63” are for possible future
use and shall not be activated until approved by the
ACMA CBRS Class Licence in Australia or the MED
GURL in New Zealand. No voice transmissions are
permitted on these channels (voice operation is inhibited
on these channels).
