7
NXDN™ OPERATION
7-6
Transmitting a call
D
Transmitting a Status message (Continued)
<Key operation>
Portable:
For the Ten-key and the Simple key types
Mobile:
For the LCD types
Using [Status]:
1. Push [Status] to display the “Status” screen.
2. Push [Up] or [Down] to select a Status Message,
then push [PTT] to transmit it.
L
“Success” is displayed after receiving an
acknowledgement from the target station.
L
“Failed” is displayed if the target station does not
send back an acknowledgement.
Portable:
For the Non-display types
Mobile:
For the Segment types
Using [Status]:
Hold down [Status] for 1 second transmit the preset
Status Message.
TIP:
This operation is enabled only when [Selector]’s
operation is set to “Status” using the programming
software.
NOTE:
The status message can be automatically
transmitted when:
•The transceiver is turned ON or OFF
L
Set the Status message to be transmitted in ‘Power ON
Status’ or ‘Power OFF Status’ item, respectively.
L
Set the target station ID in ‘Power Status ID,’ ‘Power
Status ID for Single-site Trunk’ or ‘Power Status ID for
Multi-site Trunk.’
• After sending a voice message
L
Set the ‘Send with Voice Call’ item to ‘Enable.’
L
Set the Status message to be transmitted in ‘Send
Status Number’ item.
Previous view
