8
Getting Started
Admin mode allows the user to create and change pass codes for admins and
users as well as reset the lamp counter.
Entering Admin Mode
Step 1: Turn the unit on.
Step 2: Press and continue to hold the “+” key while entering the admin PIN. The
default PIN is 1234.
Step 3: To exit admin mode, press and hold the “-” key and enter the admin PIN.
Admin mode will also exit after 60 seconds of inactivity.
PIN Management
There are two types of PINs stored in the iCleanse’s memory — administrator
PINs and user PINs. The unit must be in admin mode to make these changes.
User PIN:
Lock and Unlock unit (maximum of 16 four-digit PINs)
Administrator PIN:
Make system changes, add and remove users and
administrators (maximum of 4, four-digit PINs)
Adding and deleting PIN’s
Add an admin PIN by entering admin mode, then entering “++XXXX” and delete
by entering “--XXXX” (XXXX to be replaced by your desired 4-digit PIN)
Add a user PIN by entering “+XXXX” and delete by entering “-XXXX”
Delete all user PINs by entering “+99” (this will not delete the admin PINs)
Admin Mode
