6
10
Feed the other end of the control rod (Item 8) through
the hole at the back of the control lever (Item 10). Make
sure you push the lever all the way to the bottom.
11
Before tightening the control rod. Make sure the appli-
cation holes in the hopper are fully open and the control
lever is set at 25.
IMPORTANT
9
Protruding from the back of the hopper body (Item 9) is
a V-shaped metal bracket (Item 12-pivot bracket). Clip
the L shaped end of the control rod (Item 8) into the hole
on the V-shaped metal bracket.
12
Tighten the control rod, holding screw on the control
lever (10).
13
Affix the agitator pin (Item 5E) through the impellor shaft
inside the hopper.
Assembling your
AccuPro ONE
9
8
12
10
8
