T-CAM 300 P-SERIES USER MANUAL
14
9-1 How to Charge the Battery
Before using the imager for the first time, charge the battery for a minimum of 4 hours. The
battery status is shown by the indicator in the upper-right corner of the screen.
9-1-1 Charging via Type-C Cable
1.
Plug the Type-C end of the cable into the T-Cam Device.
2. Plug the USB end of the Type-C cable into a computer.
3. Turn computer on to start charging.
9-1-2 Charging via Power Adapter (not included)
1.
Select a charger with 5V 1A or 5V 2A output.
2.
Plug the Type-C cable into the T-Cam Device.
3. Plug the USB end of the Type-C cable into the power adapter.
4. Plug the power adapter into a 110v/120V electrical outlet.
9. Operation Instructions
ENSURE THE IMAGER IS NEAR ROOM TEMPERATURE BEFORE
CHARGING THE DEVICE. DO NOT CHARGE IN EXTREMELY HOT OR
COLD AREAS. THE BATTERY CAPACITY MAY BE DECREASED IF
CHARGED IN AN EXTREME TEMPERATURE ENVIRONMENT.
THE THERMAL IMAGER NEEDS SUFFICIENT WARM-UP TIME
FOR THE MOST ACCURATE TEMPERATURE MEASUREMENTS
AND BEST IMAGE QUALITY. THIS TIME CAN OFTEN VARY BY
ENVIRONMENTAL CONDITIONS. IT IS BEST TO WAIT A MINIMUM
OF 10 MINUTES FOR THE DEVICE TO COMPLETELY WARM-UP.
9-2 Power On/Off the Device
To turn the camera on, push and hold the Power button for two seconds. Repeat and hold for
more than 5 seconds to turn the device off.
9-3 Power On/Off the LED Flashlight
To turn the flashlight on, push and hold the LED Flashlight button for two seconds. Repeat
and hold to turn the flashlight off.