![background image](http://html.mh-extra.com/html/ichime/the-play-anything-doorbell/the-play-anything-doorbell_instruction-manual_610633008.webp)
Page
8
V. TROUBLESHOOTING
Q:
Why it will play a sound every 10 seconds.
A:
This is a diagnostic that is indicating that the outside doorbell pushbutton is stuck in the closed
position or the wires going to the doorbell pushbutton are shorted together.
Q:
Why it will play “
Beethoven’s Fifth
” every 10 seconds.
A:
This is a diagnostic that is indicating that the outside doorbell backdoor pushbutton is stuck in
the closed position or the wires going to the doorbell pushbutton are shorted together.
Q:
. Why is it that when I press
PLAY
all I hear is a beep?
A:
It is likely that the mode is set to User Recordings and that the current user location has not
been recorded. The solution is to switch to the built-in selections or record a selection to be
played.
Q:
. I have a front & back door. The front works but the back does not, why?
A:
It is possible that the “F” and “T” wires are not on the proper terminals. With a front door only
button it does not matter which wire is connected to the “F” and “T” terminals. Since the back door
button shares a common connection with the transformer it may be as simple as switching the
wires on the “F” and “T” terminals.
Q:
How do I select just one sound effect from the group?
A:
Press and hold
PLAY
until a beep is heard. The last selection played will be locked in until
either
PLAY
is pressed and held again or a selection from another category is played.
Q:
How do I select just one sound effect from the group and play twice?
A:
Press and hold
PLAY
until 2 beep is heard. The last selection played will be locked in until
either
PLAY
is pressed and held again or a selection from another category is played.
Q:
When I press and hold
REC
the red light does not come on, why?
A:
Make sure the mode is set to User Recording, by pressing the MODE button.
SPECIFICATIONS
Batteries:
4 x AA Alkaline batteries
Speaker:
8 ohms, 3 Watts
Dimensions: 5” x 7 ¾ ” x 2”
Mounting:
Horizontal or Vertical
Supports up to two 8 ohm Auxiliary Speakers