iCharger Synchronous Balance Charger/Discharger
4010DUO
- 17 -
Note:1. When the value of charge cells voltage
exceeds the recommended value (LiPo 4.2V, LiIo 4.1V,
LiFe 3.6V), the charger will sound an alarm with beep tones. As long as the user changes the
values, the battery types and cells voltage value on the main charging interface will be
displayed alternately.
2. For the setting process for all program in this manual, tick
Show
to display the setting
program on
MEMORY SETUP
(shown in the following picture), and vice versa; the built-in
program is ticked by default.
LiPo/LiIo/LiFe Battery Not Balance Charge Setup
When switch to
Not
Balance
on
Chg Mode
, Only
Chg End Current
is available for charging end condition, and
“
” behind
Chg Mod
and
Chg End Current
are inactive.
Note: 1. The charger first charges with constant current (CC) according to the user setting, then turns to
constant voltage (CV) when the charging voltage reaches the peak point. In the CV phase the
current gradually falls, and the charger will terminate charging when the current falls below
the percentage of the configured charge current. For example: the default value of Chg
Current is 2A, and the default value of Chg End Current is 10%
Chg End Current=2A*10%
=0.2A
Therefore it stops charging when the charging current reduces to 0.2A.
LiPo/LiIo/LiFe Battery Balance Charge Setup
When switch to
Slow
Balance, Normal Balance, Fast Balance or User Balance
on
Chg Mode
to activate "
"
button and click it to enter
Balance
mode setup interface.
Note: Note: On
Balance
mode, the charger will monitor the voltage of individual cells to control it
within the
Chg Cell Volt
and equalize the voltage in all cells, to avoid some cell voltage
over-charged or not full. When selecting
Balance
mode, the balance port of charger or balance
board must be connected with battery except for connecting 1S battery.
Balance Start :
CV,CV-0.1V
—
1V,Alway
Default: CV-0.2
If the balance charge voltage is 4.2V, Balance
Start set to CV-0.2V; therefore the charger will
start to balance the battery cells when the
voltage reaches to 4.2V-0.2V=4V