15
1. Removing the packing box
2. Attaching the Feet
3. Adjusting the horizontal level
4. Connecting water piping
Warning
-After removing the packing box of the ice maker, take out the provided
parts from the ice maker.
- Attach four height control stoppers among the provided parts to the bottom
of the product.
- By rotating the height control stoppers, adjust the horizontal level.
(Use the front stoppers)
- Too high temperature of the ice-making water will decrease the amount of ice produced;
too low pressure will prevent ice from being made at all. Install an auxiliary pressure pump in this case.
Ice making water drain
(3/4" FPT)
Ice making water
supply inlet (3/8" FPT)
1. Be sure to use the drinking water supply.
2. Use the product while the supply pressure is within 1 to 5 kgf/cm2(14.22 ~ 71.12 psig) and the water
temperature is within 5 to 32
℃(
41 ~ 89.6
℉)
3. Dews can form and flow down on the product door and drain hose so pay attention to that.
4. Tightly fasten the water supply hose and drain hose not to be pulled out.
5. The equipment is to be installed with adequate backflow protection to comply with
applicable federal, state, and local codes.
Installing the Product