icetro IM/WM-0460-AC, User Manual

Page: 19 / 36

3. What to check before using the product
3-1. Removal of Tapes before Operation
Water distributor Ice thickness sensor
After removing the front cover, be sure to
remove the shake prevention tapes stuck to
the sensor and the water curtain.
- Unless the tapes are removed, the machine will
not work.
3-2. Where Water Pressure Is Very Low
If the machine has been installed in a place where
water pressure is very low, remove the front cover
and then adjust the FLOATER
height to be higher within the range of avoidance of
overflow by slightly unscrewing the water level adjusting
screw.
3-3. How To Adjust Ice Thickness
You can increase the thickness of the ice by
turning the ice thickness adjusting bolt clockwise
until it is about 0.23~0.31 inches away.
(Usually, it is recommended that you avoid adjusting
ice thickness like this in order to prevent the machine
from getting excessively cold.)
Ice thickness
adjusting bolt
Evaporator
WATER LEVEL
ADjUSTING SCREW
→ ←
0.23~0.31 inches 19