22
We Think of Customer Satisfactio
n
7. Maintenance, repair and sanitization
※ Please keep the product according to the instruction manual and label provided.
● Be sure to have a qualified service technician service the product.
● To reduce the risk of electric shock, do not touch or disassemble the parts of the ice maker.
● Before service
- Turn off the power switch of the ice maker and the earth leakage breaker, and disconnect
the power plug from the outlet.
● Choking hazard
- After performing maintenance and repair, make sure that all components (such as fixtures,
screws, bolts, etc.) are completely assembled.
- Be careful not to let any components fall into the ice making compartment and ice reservoir.
※ The following maintenance schedule is guideline.
※ Maintenance and repair should be done more frequently according to water quality,
equipment usage environment and local sanitization regulations.
Maintenance schedule
Frequency
Area
Contents
Weekly
Air Filters (air-cooled)
Inspect and wash with warm water and neutral detergent if dirty
Monthly
External water filter
Make sure that the proper pressure and change if needed.
Outside of the ice maker
Wipe it with a clean, soft cloth with a neutral detergent to wipe away any
accumulated dust or grease.
Clean the chlorine staining (rust colored spots) with non-abrasive detergent.
Every six
months
Ice maker / Storage Bin
Clean and sanitize according to the sanitizing instructions given in the manual.
Gear motor and Drain Tray Check and wipe with a clean cloth and warm water.
Extruding Head Seal Bolts Check for leaks around the seal bolt. Tighten if necessary and replace O-rings.
Always replace the O-ring when loosening the seal bolt because seal material is one-
time use only.
If there is no new O-ring, apply Loctite 243 or equivalent threadlocker to seal bolt
thread.
Every year
Water supply valve and
Drain valve
Close the water supply shut-off valve and drain the water.
Clean the inlet water valve and dispense water valve screens.
Inspect and clean the drain valve
Water hoses, Condenser
Always check and inspect that it is kept clean.
Clean the hoses, condenser if necessary
Ice maker
Inspect for oil marks, loose components, tightening parts and wires.
Upper/Lower Bearing,
Dispenser solenoid silicon
Check that 0.02 inch round stock or pin gauge (or clearance gauge) is inserted
into auger and bearing clearance, and inspec silicon of dispenser solenoid
Replace all upper and lower bearing if wear exceeds factory recommendations
Replace silicon if it is wom, cracked, or scratched (Paid Service)
After Three
years,
Then Yearly
Mechanical Seal,
Upper/Lower Bearing,
Housing O-Ring,Silicon
Evaporator Cylinder, Auger
Inspect and check.
Replace both upper and lower bearings if wear excceds factory recommendations
(0.02 inch).
Replace mechanical seal, O-rings, silicon if it is worn, cracked, or scratched.
(Paid Service)
