GB
2
A. INTRODUCTION
This manual provides the specification and the step-by-
step procedures for the installation, start-up and opera-
tion, maintenance and cleaning for the Icemakers.
The machine cubers are quality designed, engineered and
manufactured.
Their ice making systems are thoroughly tested providing
the utmost in flexibility to fit the needs of a particular user.
This product qualifies for the following listings:
These icemakers have been engineered to our own rigid
sefety and performance standards.
The VDE - SEV - GS seals signifity that it is listed with
them and that it complies with the materials and manufac-
turing standard of them. These seals also signify that
these icemaker models have been inspectors who reserve
tha right to periodically examine production icemakers at
the factory to assure continued compliance.
NOTE. To retain the safety and performance built into
this icemaker, it is important that installation and mainte-
nance be conducted in the manner outlinde in this man-
ual.
B. UNPACKING AND INSPECTION
1. Call your authorized Distributor or Dealer for proper
installation,.
2. Visually inspect the exterior of the packing and skid.
Any severe damage noted should be reported to the
delivering carrier and a concealed damage claim from
filled in subjetto inspection of the contents with the car-
rier’s representative present.
3. a) Cut and remove the plastic strip securing the carton
box to the skid.
b) Remove the packing mails securing the carton box
to the skid.
c) Cut open the top of the carton and remove the poly-
styre protection sheet.
d) Pull out the polystyre posts from the corners and
then remove the carton.
4. Remove the front and the sides panels of the unit and
inspect for any concealed damage. Notify carrier of
your claim for the concealed damage as stated in step
2 above.
5. Remove all internal support packing and masking tape.
6. Check that refrigerant lines do not rub against ou touch
other lines or surfaces, and that then fan blades move
freely.
7. Check that the compressor fits snugly onto all its
mounting pads.
8. See data plate on the rear side of the unit and check
that local main voltage corresponds with the voltage
specified on it.
CAUTION. Incorrect voltage supplied to the ice-
mark will void your parts replacement program.
9. Remove tha manufacture’s registation card from the
inside of the User Manual and filling all parts including:
Model and Serial Number taken from the data plate.
Forward the completed self-addressed registration
card the factory.
GENERAL INFORMATION
Summary of Contents for N25S
