Icematic N25S, Service Manual

Page: 14 / 24

GB
12
c. Trace the electric wire leads of paddle motor and dis-
connect the same; then remove the paddle shaft motor
assy.
d. Remove the paddle shaft assy from the paddle motor
gudgeon (or guide pin).
e. To install the replacement paddle motor follow previous
steps in reverse.
L) HARVEST MOTOR REPLACEMENT
a. Remove the top cover.
b. Remove the screws securing the harvest motor to the
cabinet base.
c. Remove the seeger from the cam pin.
d. Trace the electric wire leads of harvest motor and dis-
connect the same; then remove the harvest
motor/cam/support assembly.
e. Remove the lock pin securing the cam to the motor
shaft and the screws joining the harvest notor to the
relative support.
f. Install the replacement harvest motor on the support
and apply the cam; make a Ø 3 mm hole on the motor
shaft and to do it take as a guide the hole already exist-
ing on the cam.
g. To install the replacement harvest motor assy follow
previous steps in reverse.
M) THERMOSTAT OR RELAY REPLACEMENT
a. Remove the rear panel on N25S model.
On N35S÷N140 models remove the top cover.
b. Remove the terminal box cover.
c. Remove the screws securing the terminal box to the
cabinet.
d. Slightly lift the terminal box and remove the screws
securing the thermostat or the Relay to the box same.
e. Remove the Relay or the Thermostat; in this last case
remove the supports securing the bulb in the storage
bin first, the lift it from the storage bin through the prop-
er slit.
f. To install the replacement thermostat or relay follow
previous steps in reverse.