5. Place the focus on
Move
and press the left or right navigation button to
finely drive the dish east or west for the best signal. The dish rotates con-
tinuously as long as either of these buttons is held down.
6. Choose
Store Satellite Position
from
Positioner Command
to save the dish’s
current position for the target satellite.
It may be useful to set limits to the movement scope of the dish for easier ma-
nipulation. Repeat these steps two times to set a limit position for the east and
the west.
1. Choose
Go to Reference
from
Positioner Command
for the dish to return
to the reference point.
2. Place the focus on
Move
and press the left or right navigation button to drive
the dish.
3. Choose
Set East (soft) Limit
or
Set West (soft) Limit
from
Positioner Com-
mand
to save the dish’s current position to use it as a limit position.
Choosing
Disable (soft) Limits
from
Positioner Command
clears these limit po-
sitions.
Using USALS
Open the apps screen and select
Settings
>
Positioner Setting
. Set
Positioner
to
USALS
and then specify these items correctly:
•
Dish Longitude
: Enter the longitude where the dish is located.
•
Dish Latitude
: Enter the latitude where the dish is located.
Give the dish a test run to see if it works properly. Repeat these steps for every
desired satellite.
1. Choose
Go to Reference
from
Positioner Command
for the dish to return
to the reference point.
2. Choose
Satellite
and choose a target satellite.
3. Choose
Frequency
and select any available transponder.
4. Choose
Go to
to rotate the dish so that it faces the target satellite.
S C
25
