Ice i20NB, Operator'S & Parts Manual

Page: 11 / 49

11 ICE i20NB / i20NBT / i20NBT-OB / i24BT
OPERATOR MANUAL
FAULT CODE & SOLUTION
FAULT
CODE FAULT MESSAGE
MODEL
FAULT CAUSE SOLUTION
i20NB
i20NBT
i24BT
F01 Lower Brush Deck
●
Brush deck is off the floor
Release the control handle bail
Or Lower the Brush deck
F04
Vac Mtr O.L.
RE-START!
● ●
Vacuum motor overload
Turn off the machine,after a
moment, RE-START machine
F06
Bru Mtr O.L.
RE-START!
● ●
Brush motor overload
F07
Propel Mtr O.L.
RE-START!
●
Propel motor overload
F08 RecTank Full
● ●
Recovery tank is full
Or Bad Solution level sensor
Drain the Recovery tank/Replace
the solution level sensor
F10
Batt Low
Charge Batt
● ●
Battery is low Charge the battery
F11
Batt Empty
Charge Batt NOW
● ●
Battery is empty Charge the battery NOW
F12
Brake Wiring
Error
●
Bad Brake wiring
Bad Brake
Check the brake wiring
Replace the Brake assembly
F14 Replace Brake Assy
●
Bad Brake assembly Replace the brake assembly
F16
Control Unit
Overheat! Wait
● ●
Control Unit Overheat
Turn off the machine,after a
moment, RE-START machine
F17 Replace Control Unit
● ●
Control Unit Fault Replace the control unit
F21 Check Vac Mtr
● ●
Bad Vacuum motor or wiring Check the vacuum motor / Wiring
F22 Check Soln Solenoid
● ●
Solution solenoid wiring fault Check the wiring & Contactors
F23 Replace Soln solenoid
● ●
Bad Solution solenoid Replace the solution solenoid
F24 Check Propel Motor
●
Bad propel motor Check the propel motor / Wiring
F25 Check Brush Motor
● ●
Bad brush motor Check the brush motor / Wiring
F40 Check Proximity Sw
● ●
Proximity switch fault Check the Proximity switch
F41 Release Handle
● ●
Operation mistake Release the control handle bail
F42 Replace Control Unit
● ●
Bad Control Unit Replace the control unit
F43
Turn Dead Sw Off
RE-START!
●
Emergency stop button
activated.
Release emergency stop button
and restart machine.
F44 Replace Control Unit
● ●
Bad Control Unit
Contact service center, Replace
the Control Unit
F45 Return Control Unit
● ●
F46 Return Control Unit
● ●
F47 Return Control Unit
● ●
F48 Return Control Unit
● ●
The machine is equipped with a LED display
screen (see Panel components, item # 4), the LED
screen will display the operating hours (see Panel
components, item # 12) and the battery level status
(see Panel components, item # 2).
When the machine detects a fault, there will be
a Fault code (see Panel components, item #11)
& Fault message (see Panel components, item
#8) display on the LED screen, and the Fault
indicator (see Panel components, item #1) will
flash continuously, accompany an audible alarm
Occasionally.
Once fault occuring, please DO NOT continue
operate the machine unless the fault are eliminated.
Turn off the machine, then to solve the fault, the
fault code & message will be eliminated when
machine restart.
If the fault is occurred frequently, or the fault can't
be eliminated, please contact ICE service center.
Please refer to the below table to determine the
fault cause and the solution.