7
ICCONS® GAS TOOL GT6-IXF USER MANUAL
5 Tool Operation
5.1 Charging
Steps:
1. Plug the battery charger into the proper AC
voltage source, green light will be flashing.
2. Insert the battery into charger, red light will
alight indicating the battery is charging.
3. It takes about 60 minutes for charging.
4. When fully charged, green light will remain
alight.
5. After charging, unplug the charger from the
power source.
• If orange light is blinking, remove the
battery cartridge and plug again.
• If this happens continuously, the battery
cartridge or charger may be damaged.
Consult authorized service agent for
replacement of new battery cartridge.
NOTE:
• Never attempt to open the charger or
battery cartridge.
• The battery charger is for charging specific
battery pack. Never attempt to charge
battery pack from other manufacturer’s
battery cartridge. Unsuitable battery
cartridges may cause fire that causes injury.
• When the battery charger is being used,
keep out of direct sunlight.
• To get better cooling effect, keep the
exhaust area clean.
•
5.2 Installing & Removing The Battery
Steps:
1. Empty fasteners from the magazine and
make sure the trigger is not pulled while
installing the battery.
2. To install the battery, insert the battery
cartridge until hearing a “click”.
3. To remove the battery, grip the buttons on
both side of battery cartridge and pull out.
5.3 Battery Light Indicator
LED
Battery Level
All LEDs
100%
1 Green and 1 Red LED
50%
1 Red LED
25%
NOTE:
After using the tool, remove the battery from the
tool to prevent the tool from being fired.