10
PART 4 - INSTALLATION
4.1 - Positioning of the machine
Fill the water tank. Make sure you put in
more than the
minimum amount
re-
quired for machine operation (75 mm
from the top of the tank) but do not ex-
ceed the
maximum level (20 mm from
the top of the tank)
.
Connect the Roner to the immersion
tank by means of the connector behind
the machine.
Make sure the liquid does not enter the
machine.
4.2 - Connection to the mains
The machine has a power cable (3x1.5 mm² x 2.5 m) and a 16A Shuko plug. Connect
the 230 V 50 Hz machine by installing a 10A I = 0.03A residual-current device on the
line. Also check that the information on the machine's nameplate match the specifica-
tions given in the delivery and shipping documents, and that both the master switch
and cable are easily accessible while the machine is in use.
4.3 - Wiring diagram
Fig. n°6
Fig. n°5
NTC2
NTC1
FLOAT
POWER BOARD
KEYBOARD
BOARD
SWITCH
ELEMENT
SAFETY