iCanServer440R User’s Guide
5.5. Sensor & Capture Setup
This is the setup page for conditions of video capture. The video capture can be triggered either
by activated alarm sensor or motion detection as setup by this page. When the video capture
condition is med, the situation is notified to users through iNVR. Captured video is stored on the
HDD of the iCanServer440R.
Figure 5-7. Sensor & Capture Setup
y
Sensor Setup
: 4 Sensors can be connected to iCanServer440R.
-
Type Selection : Select sensor type. There are two types of sensors
. Normal Open : “floating” in normal situation, non-floating means an alarm condition.
. Normal Close : “non-floating” in normal situation. Floating means an alarm condition.
y
Video Capture Condition
: It sets the condition of video recording. The iCanServer440R supports
3 types of conditions :
1. Sensor : when at least one of the sensor detects alarm condition.
2. Motion-detected : when motion is detected from video channel
Above 2 conditions are mutually independent in operation.
y
Sensor Select : Select the sensor that triggers video capture.
y
Motion Detection Select : Select the video channel that triggers video capture.
Rev.2.0 (Aug. 2004)
30
