iCanServer440R User’s Guide
2.
Assign IP address to iCanServer440R using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide]
.
If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
3.
Connect to iCanServer440R in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanServer440R is delivered to you.
You are asked to configure the system for your environment in administration mode.
Detailed information of using administration mode can be found in
[5.
Configuring the
A/V Server in Administrative Mode]
. Among the parameters, the parameters in the
following table should be set-up in proper values. Detailed information for the parameters
in Administrator Mode be found in
[5.
Configuring the A/V Server in Administrative
Mode]
[Note]
: Set-up values are preserved even the power is turned off.
Page
Parameter
Setup value
Factory default value
Max Upload
Bandwidth
Set this value lower than
allowed upload bandwidth.
10Mbps
Basic
Setup
Max Users
Number of users you want to
allow
10users
Administrator name
& password
For safety, you are
recommended to change
these values from factory
default. For new connection,
you need to input changed
values for corresponding
fields. Do not expose these
values to others and
memorize these values.
Username : root
Password : dw2001
User
Admin &
Time
Setup
Current Time
Input correct time to this
field.
2001/1/1
4. Connect the inputs and output signals to iCanServer440R.
iCanServer440R does not function properly if there is no video and audio input.
Refer to the following table. You have to connect at least one Video In.
Connectors
Function
Signal description
Number
Video In
Input video
Analog video outputs from analog
1 to 4
Rev.2.0 (Aug. 2004)
12
