iCable System ICS-G302, Operator'S Manual, Page: 24 / 63

Page 24
2.2 Normal Installation Procedure
The table below shows the procedures to install S-MTA. There are slight
differences for installation depending on the networking device such as xDSL
modem and cable modem.
STEP 1 In order to establish connection with WAN-side networking device such
as Cable Modem or xDSL modem, one end of RJ-45 Ethernet Cable
should be connected to the Ethernet Port on WAN-side networking
device, and the other end to WAN Port on S-MTA.
STEP 2 In case Ethernet Interface is used between S-MTA and user’s PC, one
end of Ethernet cable should be connected to PC port on S-MTA, and
the other end to Ethernet port on Ethernet card installed in user’s PC.
STEP 3 For the telephony service, one end of a RJ-11 Telephony cable should be
connected to RJ-11 port of ordinary telephone, and the other end to TEL
port on S-MTA.
STEP 4
Connect Power Adaptor to DC/12V power jack of the S-MTA.
STEP 5 Turn on the PC and Modem.
STEP 6 Push the On/Off Switch Button on the rear panel of S-MTA for power.
STEP 7 After S-MTA is booting, you can change the default configuration of S-
MTA by using S-MTA’s embedded web pages.