ICA AQUA OCEAN AQ13000, Instruction Manual

Page: 7 / 16

Install Your Wave Maker
Warnings
• The pump is suitable for aquarium thickness within 15mm.
• Do well connect the pump ,controller ,adaptor before plug in.
• Take care the magnet, as it is with Powerful Magnets and can cause Personal Injury.
• Protect the pump from falling.
• Don’t align the magnet directly to the pump.
1. Remove the outer magnet from the magnet seat /sump ,place the pump upon the tank wall in your
pre-determined location . Take core to place the pump in a suitable location where corals are not
placed directly in the line of flow. Recommend a depth of 15cm under the water for your wave
maker location.
2. Put magnet to the outer tank wall a little far away from the pump, and then move the magnet slow
to align the pump.
3. Place the controller on the tank with adhesive tape or place on your pre-desired location.
4. Connect the pump with the controller ,adaptor and then plug in the power supply.
30% 100% SPEED FEED
LIGHT
MODE
MODE LOCK
Light Sensor
10min
Fast Slow
M1 M2 M3 M4
M2 M3 M1 M4
W-25
W
av
em
ake
r C
on
tr oll
er
NO
OK
SPEED
FEED
MODE
LIGHT
MODE
LOCK
Light Sensor Fast
M1
M1 M2 M3 M4
M2
10min
30% 100%
W avem
aker Con
troller
M3 M4
Slow
Fig.1
Fig.2
• Once you choose the location where you want to install the pump, clean
away any algae, calcified etc.
• Take core to place the pump in a suitable location where corals are not
placed directly in the line of flow.
• Controller ,adaptor are not water proof. Protect these components from
any contact with water.
Note