17
ranges from 4.0~6.0 mm. It is very convenient for you to do the waterproof work when you pull the cable
through your own exit. Please refer to the steps listed.
Step 1
Take the waterproof airproof plug out, pull the cable (diameter ranges from 4.0 to 6.0 mm) through the
waterproof airproof plug. See Figure 3- 8.
Figure 3- 8 Cable connection
Step 2
Before you go to Step 3 in Chapter 3.2.1, please pull through cable with the waterproof airproof plug to
the device chassis via the installation hole at the bottom of the chassis and then connect the cable pins.
Step 3
Refer to Step 3 in Chapter 3.2.1, install and connect the cable pin to the device and then follow the
proper steps to go on the installation.
For non vandal-proof series, pull the cable through the anti-dust plug on cable exit of the device chassis.
Important
This series product has the power connection pin and I/O connection pin for you to pull through
the signal cable.
3.3
Micro SD Card Installation
Warning!
Please unplug the device power cable and then shutdown the device before you install the Micro
SD card.
Step 1
Please refer to Step 2 in chapter 3.2.1 to open the device protection enclosure.
Step 2
Please find the “SD” mark inside the device and adjust the Micro SD card direction according to prompt
direction. Insert the card to the slot and then install the Micro SD card. See Figure 3- 9.
