14
Step 3
Adjust the device chassis and pull the cable through the exit hole. Make fixture hole on chassis face the
three plastic expansion bolts (in Step 1). Take 3 ST3.0 self-tapping screw out from the accessories bag
and fix them on the three plastic expansion bolts to secure the chassis on installation surface.
Note:
Make host GND grounded which can improve device reliability. For outside installation, the host
GND must be grounded.
GND of vandal-proof series locates next to its exit hole. GND of non vandal-proof series locates at
rear of the camera.
Device grounding screw dimension is M3X0.5 with valid depth 5mm.
Step 4
Adjust angle of the lens according to actual need.
a) For the IR series product, you can skip current step and go the step b) directly. For the non-IR
series product, push the port slightly to remove the decoration enclosure from the black plastic
enclosure. See Figure 3- 5.
Figure 3- 5 General installation 3
b) Lens pan rotation angle setup. Please refer to Figure 3- 6 to unfasten the lock screw A and adjust
the pan monitor angle to the proper position. Then fix the lock screw A. The pan angle ranges from
0°~350°.
c)
Lens tilt rotation angle. Please refer to Figure 3- 6 to unfasten the lock screw B and lock screw C
and adjust the tilt monitor angle to the proper position. Then fix the lock screw B and lock screw C.
The tilt angle ranges from -20°~+70°.
d). Image pan rotation angle setup. Please refer to Figure 3- 6 to turn lock screw D to adjust the video
pan angle. Then fix the lock screw B and C. The video pan angle ranges from 0°~+350°.
