4
3
Installation
Important
Before the installation, please make sure the installation surface can sustain at
least 3X weight of the bracket and the camera.
Figure 3-1
Step1
Take the installation position map from the accessories bag, and stick it on the ceiling or wall
according to the cable exit, dig four holes according to the instruction on the installation
position map, then take out four expansion bolts from accessories bag and put them into the
installation holes and fix them.
Step 2
Open decoration ring and take down enclosure and dome body
Step 3
Adjust the pedestal position according to the cable exit mode (ceiling/side), Pull the cable
through the cable side exit at the installation surface and the pedestal (Please skip this step if
you want to use ceiling exit mode). Line up the screw holes at the bottom of the pedestal to the
holes of plastic expansion bolts in the installation surface. Put four self-tapping screws to
expansion bolts and then secure firmly, and fix the pedestal on the installation surface, see
