18
Use this item to turn on/off the Mid Level Cache (L2) streamer prefetcher.
Adjacent Cache Line Prefetch
The optional settings are: [Disabled]; [Enabled].
Use this item to turn on/off prefetching of adjacent cache lines.
EIST
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable Intel SpeedStep.
CPU C Status
Use this item to enable or disable CPU C status.
The optional settings: [Disabled]; [Enabled].
SATA Configuration
Press [Enter] to make settings for the following sub-items:
SATA Controller(s)
The optional settings: [Disabled]; [Enabled].
*When set as [Disable], user can make further settings in ‘
SATA Mode Selection
’.
SATA Mode Selection
The optional settings are: [IDE]; [AHCI]; [RAID].
*When set as [AHCI] or [RAID], user can make further settings in ‘
SATA
Controller Speed
’.
SATA Controller Speed
The item is for user to set the maximum speed the SATA controller can support.
The optional settings are: [Default]; [Gen1]; [Gen2]; [Gen3].
*When set as [AHCI] or [RAID], user can also make further settings for each
available SATA (1~6) port or MSATA port:
Serial ATA Port 1/2/3/4/5/6/ m-SATA
Port 1/ Port 2/ Port 3/ Port 4/ Port 5/m-SATA
The optional settings: [Disabled]; [Enabled].
Use this item to enable or disable each SATA port.
Intel(R) Rapid Start Technology
Press [Enter] to go to next screen to enable or disable ‘
Intel(R) Rapid Start
Technology’.
*When set as [
Enabled
], user can also make further settings in the following items
that appear:
Entry on S3 RTC Wake
Use this item to enable or disable RapidStart innovation upon S3 RTC wake.
Entry After
Use this item to enable RTC wake timer at S3 entry. Value ranges from 0
(immediately) to 120 minutes.
Active Page Threshold Support
Use this item to enable or disable support for RST with small partition.
PCH-FW Configuration
Press [Enter] to view ME information and make settings for ‘
Firmware Update
Configuration’
.
Firmware Update Configuration
Use this item to configure Management Engine technology parameters. Press
[Enter] to make settings for ME FW Image RE-Flash.
