IBT Technologies IB500, User Manual

Page: 71 / 78

SCSI DRIVERS INSTALLATION
IB500 User’s Manual 67
Installing SCSI driver for OS/2 3.X & 4.X
I) Installation procedures for INI-A100u2W OS/2 3.X & 4.X device
driver:
A) Installed as a secondary controller
1) Open the OS/2 System Folder.
2) Open the System Setup Folder.
3) Double-click "Device Driver Install".
4) Insert the Initio installation diskette into your floppy drive.
5) Change to the OS/2 directory.
6) Choose INIA100.ADD, then click INSTALL.
7) After installation is done, OS/2 will report the status.
B) Installed as a primary controller
1) Make backup copies of the OS/2 Diskette 1.
2) Copy the INIA100.ADD onto OS/2 Diskette 1.
3) Modify the config.sys file on Diskette 1 to add
BASEDEV=INIA100.ADD /V
4) Install OS/2 using the backup Diskette 1
II) Driver configuration options:
/V Verbose mode provides detail information about driver
when driver is initialized
/!V Non Verbose mode (default)
/ET Driver assumes that all targets have more than one LUN
(default)
/!ET Driver assumes that all targets only have LUN 0
/Q:x Specifies maximum number of tag commands per target
/!Q No tag command
/B:(d,dd),. Scan devices only on PCI BUS d, DEVICE dd
/B:d
Scan all the devices on the PCI BUS d
/T:xxxx Target enable mask WORD (Default scan all targets)
/A:d
Adapter IDs are assigned based on BIOS address and ..then
PCI device address
/DM:d,.. Enable direct access storage device (DASD) support on
target d
/!DM:d,.. Disable DASD manager support on target d
/SM:d,.. Enable SCSI manager support on target d
/!SM:d,.. Disable SCSI manager support on target d