10
3.5 Configuring the CPU
The HS-2608 v2.0 embedded with a ULV Intel® Celeron® processor
400MHz/650MHz. User don’t need to adjust the frequently and check
speed of Intel® processor.
3.6 System
Memory
The HS-2608 v2.0 provides one SO-DIMM socket at locations
DM1
.
The maximum capacity of the onboard memory is 512MB.
3.7 DiskOnChip
Address Setting
The DiskOnChip
function allows the system to boot or operate
without a FDD or a HDD. DiskOnChip
modules may be formatted as
drive C or A. With DiskOnChip
, user may also execute DOS
commands such as FORMAT, SYS, COPY, XCOPY, DISCOPY and
DISKCOMP etc.
The U1 location on the HS-2608 v2.0 is the DiskOnChip
module
socket. Jumper
JP4(1-4)
assigns the starting memory address of the
installed module. If you have another memory device that has a similar
memory capacity with that of the DOC in your system, please set both
at different memory address mapping to avoid the mapping area
conflicts. Failing to do so will not make the HS-2608 v2.0 and the
additional memory device function properly.
JP4(1-4): DiskOnChip
Address Select
Address
PINS 1-2 PINS 3-4
D000 (default)
Short
Short
D800
Open Short
E000
Short Open
3.7.1 Installing DiskOnChip
Modules
When installing a DiskOnChip
module onto your board, please take
note of the following:
1. Orient yourself properly with the location of the DiskOnChip
socket. Try to locate the pin 1 location on your socket. Pin
numbers are usually printed on either the component side or the
solder side of your board.
