49
6.2.2. Assembly of the IBS-Special Pump
∙
Insert the pump (4) in the barrel (5) and place the assembled device above the barrel (5).
∙
Screw the enclosed return supports into the ¾-inch opening of the 50 litre barrel.
∙
Plug the return pipe (6) into the return connectors.
∙
Secure the upper end of the return pipe (6) on the drain connection (8) of the tub.
∙
Secure the return pipe onto the return pipes and the drain connection with the two clamps enclosed.
∙
Feed the brush hose (9) through the round hole in the rear wall of the tray (10) and insert the cleaning brush.
∙
Place the foot-operated safety switch (7) in front of the device.
∙
Insert the plug into the 230 V socket.
∙
Perform a function test: cleaning liquid must flow when the foot switch is pressed.
6.2.3. Operation
∙
Place the workpiece to be cleaned on the support rack.
∙
Press the foot switch to turn the device on.
∙
Clean the workpiece with the brush.
∙
Release the foot switch to turn the pump off.
6.2.4 Changing the drum
∙
Detach the brush hose from the pump.
∙
Remove the return hose from the drum.
∙
Switch off the power supply to the pump.
∙
Pull the collecting tray (optional) out from under the IBS-Parts Cleaning Device.
∙
Remove the pump from the drum. Seal the drum with a 2“ sealing cap for the drum body.
∙
Replace the drum and push the collecting tray back under the IBS-Parts Cleaning Device.
∙
Assembling the IBS-Special Pump (refer to section 6.2.2.).
NOTE
Please complete the warranty card (form) which you will find at www.ibs-scherer.com.
6.3. Fault identification and troubleshooting
Fault
Cause
Solution
Pump not working
No power
Check that mains plug is plugged in
Pump is faulty
Replace pump
Pump not working
Liquid level in drum is too low
Check liquid level, if necessary ask IBS Scherer to change
the drum
Pump is faulty
Replace pump
If the steps described above do not resolve the problem please call 0049-67 01-93 83 -0 or contact us per e-mail at [email protected].
IBS-BA_Typ_BK 50-DE_CZ_PL_ES_EN_04.2020
EN
