IBM xSeries 342 2RX, Maintenance Manual, Page: 102 / 158

Error Code/Symptom FRU/Action
1600 (The Service Processor is not
functioning) Do the following before
replacing a FRU:
1. Ensure that a jumper is not installed
on J45.
2.
Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
1. System Board
1601 (The system is able to communicate
to the Service Processor, but the Service
Processor failed to respond at the start of
POST.) Do the following before replacing
a FRU:
1.
Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
2. Flash update the Service Processor.
1. System Board
1762 (Fixed Disk Configuration error)
1. Fixed Disk Drive
2. Fixed Disk Cables
3. Run Configuration/Setup
4. Fixed Disk Adapter
5. SCSI Backplane
6. System Board
178X (Fixed Disk error)
1. Fixed Disk Cables
2.
Run Diagnostics
3.
Fixed Disk Adapter
4.
Fixed Disk Drive
5. System Board
1800 (No more hardware interrupt
available for PCI adapter)
1. Run Configuration/Setup
2. Failing Adapter
3. System Board
1962 (Drive does not contain a valid boot
sector)
1. Verify a bootable operating system is installed.
2. Run Diagnostics
3. Hard Disk Drive
4. SCSI Backplane
5. Cable
6. System Board
2400 (Video controller test failure)
1. Video Adapter (if installed)
2. System Board
2462 (Video memory configuration error)
1. Video Adapter (if installed)
2. System Board
94
Hardware Maintenance Manual: xSeries 342 Model 1RX, 2RX, 1TG, 2TG