IBM Types 2193, User Manual

Page: 160 / 214

10-18
IBM Personal Computer User Guide
1701 Hard disk(s) diagnostics fail 1. Determine if the hard disk is defined
correctly in BIOS Setup.
2. Check the hard disk drive cable/
connection.
3. Check the hard disk drive.
1762 Primary master IDE has
changed
Primary slave IDE has
changed
Secondary master IDE has
changed
Secondary slave IDE has
changed 1. Make sure the System Boot Drive
parameter in the Startup Options of
BIOS Setup is not set to (Drive A only).
2. Load the default settings in Setup.
3. Insert a system diskette into the
diskette drive and reboot the system.
4. Ensure the diskette drive configuration
setting in BIOS Setup is correct.
5. Check the power to the hard disk drive.
6. Check the Diskette Drive.
1780 Primary master hard disk fail 1. Load the default settings in Setup.
2. Check the IDE drive jumper.
3. Check the power to the IDE drive.
4. Check the IDE cable/connection.
5. Check the IDE drive.
1781
Primary slave hard disk fail 1. Load the default settings in Setup.
2. Check the IDE drive jumper.
3. Check the power to the IDE drive.
4. Check the IDE cable/connection.
5. Check the IDE drive.
1782
Secondary master hard disk
fail 1. Load the default settings in Setup.
2. Check the IDE drive jumper.
3. Check the power to the IDE drive.
4. Check the IDE cable/connection.
5. Check the IDE drive.
Table 4: Error codes and messages (Continued)
Error codes Error messages Corrective actions
Note: If any of the errors persist after performing the listed corrective actions, see “Chapter
2. HelpWare support and services” for information on obtaining service.