IBM THINKCENTER 8128, Hardware Maintenance Manual

Page: 19 / 290

v
If the test stops and you cannot continue, replace the last device tested.
006
IS A POST ERROR CODE DISPLAYED?
If YES, go to “POST error codes” on page 92.
If NO, continue to
007
.
007
1. Power-off the computer.
2.
Press and hold the F1 key and power-on the computer to start the IBM Setup
Utility program (see Chapter 5, “IBM Setup Utility program,” on page 19).
Release the F1 key when you hear beeps.
3. Select Exit, Load Default Settings, and Save and exit the Setup Utility.
4. If the problem persists, continue to
008
.
008
Run the Diagnostic programs. If necessary, refer to Chapter 4, “IBM Enhanced
Diagnostics,” on page 15.
v
If you receive an error, replace the part that the diagnostic program calls out or
go to Chapter 7, “Symptom-to-FRU Index,” on page 69.
v
If the test stops and you cannot continue, replace the last device tested.
Chapter 3. General Checkout
13