IBM System x3400 M3 Types 7378, Installation And User Manual

Page: 106 / 154

8. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the left-side cover (see “Removing the left-side cover” on page 49).
4. Unlock the retention latch by pushing it down toward the system board.
5. Align the flash device with the USB connector on the system board and push it
into the USB connector until it is firmly seated.
6. Return the retention latch to the locked position by pulling it away from the
system board.
7. Reconnect the power cord and any cables that you removed.
8. Install and lock the left-side cover (see “Completing the installation” on page
98).
9. Turn on the peripheral devices and the server.
Installing a second microprocessor
The following notes describe the type of microprocessor that the server supports
and other information that you must consider when you install a microprocessor:
v
Microprocessors are to be installed only by trained service technicians.
90
IBM System x3400 M3 Types 7378 and 7379: Installation and User's Guide